Printronix LQH-HWTM manual Bar Code Errors, Missing or wrong delimiter must be a colon

Bar Code Errors

84Missing or wrong delimiter - must be a semicolon ;

The delimiter is either wrong or missing. The delimiter expected is a semicolon.

85Missing or wrong delimiter - must be a colon :

The delimiter is either wrong or missing. The delimiter expected is a colon.

86DENSITY param error - 10, 10A, 10B, 12, 13, 15, 17 or 20 The parameters of the Density command are improperly specified. The densities currently implemented are 10, 10A, 10B, 12, 13, 15, 17 and 20 characters per inch. The command is ignored and processing continues.

87LPI parameters error - must be 6, 8, 9, 10

The parameters of the LPI command are improperly specified. The only parameters implemented are 6, 8, 9, and 10 lpi. The command is ignored and processing continues.

88Bar code type is not supported

The specified bar code type is either misspelled or not supported.

89EXPAND parameters out of bounds or format error The parameters of the Expand command are improperly specified. Either the parameters are out of bounds, or some type of format error was detected. The command is ignored, and processing continues.

Bar Code Errors

90Insufficient memory to store the BARCODE

No more room exists in the IGP memory for another bar code. The rest of the bar code commands are flushed until the Stop command is found. Then, processing continues.

91ALPHA/BARCODE syntax error

Some type of syntax (format) error was detected in the parameters of the bar code command. This error is usually caused by one or more of the following:

a.Misspelled keywords;

b.Lowercase used;

c.A missing semicolon;

d.A colon in place of a semicolon;

e.An ending delimiter for the data field was not found;

f.Too many or too few parameters in the command string.

The rest of the command line is flushed until the Stop command is found. Processing will then continue.

92BARCODE magnification factor MAG out of bounds or not allowed

The magnification factor specified in the bar code command is out of bounds. Refer to the applicable section in the “Bar Codes” chapter to determine the acceptable magnification values for the bar code symbol being used.

271