Printronix LQH-HWTM manual End

Chapter 2 Command Codes

Comments The IGP/PGL configuration parameters available are defined in your User’s Guide.

Any or all parameters can be used within one CONFIG command, and they can be listed in any order. List each parameter;value on a separate line, terminating with the END command. Default configuration values can be reset using the CONFIG command.

Parameters not followed by a value, and parameters followed by any non-zero value are interpreted as “true” or “enabled” values. For carriage return and line feed definitions, a zero value does not change the data stream. However, for non-zero values, a carriage return character or line feed character will be interpreted as a carriage return plus a line feed.

Parameters not listed in this command remain unchanged. If a parameter error is detected for parameters other than 0 or 1 (i.e., SFCC, Top/Bottom Margin, Left Margin), the value will default to the current configuration from disk/flash.

Example 1 The following command enables IGP/PGL Auto Wrap, disables Auto Eject, and selects 6 lpi printing.

~CONFIG AUTO WRAP;1

AUTO EJECT;0 LPI;6

END

Example 2 The following command resets all control panel IGP/PGL configuration parameters back to default values.

~CONFIG RESET END

48