Printronix LQH-HWTM Lines, Vertical

Lines, Vertical
73
Lines, Vertical
Purpose Defines vertical lines.
Mode CREATE
Format VERT
LT; C; SR; ER
STOP
VERT The Vertical Line command; enter VERT.
LT Defines the line thickness, measured in 1/60-inch
dots. Enter a value of 1 or greater. Vertical line
thickness expands to the right from the starting
column.
C Defines the column where the vertical line begins.
Enter a value ranging from column 1 through one
less than the width of the form. Character column
or dot column is specified based on the Scale
command (page 83), or use the CP.DP format
(page 26).
SR Defines the starting row of the vertical line. Enter a
value ranging from row 1 through one less than the
length of the form. Character row or dot row is
specified based on the Scale command (page 83),
or use the CP.DP format (page 26).
ER Defines the ending row of the vertical line. Enter a
value ranging from row 2 through the last row of the
form. The ending row must be greater than the
starting row. Character row or dot row is specified
based on the Scale command (page 83), or use the
CP.DP format (page 26).
STOP Stop indicates the end of the VERT command;
enter STOP. If not entered, the IGP expects
another set of Vertical Line command parameters.
Example The following program specifies 4 vertical lines. To illustrate
positioning, the starting row and column are indicated on the
example but do not necessarily reflect actual location on the
page.