Chapter 2 Command Codes

Configuration

Purpose Places the IGP/PGL in the Configuration mode, where changes to any or all of the IGP/PGL configuration parameters via software control can be made instead of from the printer control panel.

Mode NORMAL

Note A separate line is required for the CONFIG command, the parameters and values, and the END command.

Format (cc)CONFIG

parameter;value

END

(cc)The SFCC.

CONFIG

The Configuration command; enter CONFIG.

parameter;value

The parameter for which a configuration change is desired, and the value associated with that parameter. The available parameters and the values associated with these parameters are listed in Table 6.

END

Terminates the CONFIG command; enter END.

Note All CONFIG parameters except RESET must be followed by a semicolon (;). Any CONFIG parameters not entered in UPPERCASE and exactly as listed in Table 6 will result in an Error 156. (Refer to the “Error Codes” chapter.)

46

Page 46
Image 46
Printronix LQH-HWTM manual Configuration, Parametervalue, End