Printronix LQH-HWTM manual Modes of Operation Normal Mode Commands Mnemonic Description

Modes of Operation

Table 1. Normal Mode Commands

Command	Mnemonic	Description	Page #
Compressed Print	DENSITY	Defines the horizontal print density in characters per inch (cpi).	45
Configuration	CONFIG	Reconfigures IGP/PGL parameters	46
Create	CREATE	Places the IGP in the Create Form Mode where all the Create	51
		Form Mode commands are available to design form elements.
Create Logo	LOGO	Places the IGP in the Create Logo Mode, where logos can be	76
		defined using the appropriate dot placements.
Delete Form	DELETE	Deletes a selected form name from the directory and IGP	52
	FORM	memory.
Directory	DIRECTORY	Provides a list of all defined forms and logos, logo assignments	53
		to forms, and memory usage and availability.
Emulation Switch	EMULATION	Switch emulation from IGP/PGL to IGP/VGL (if VGL is present)	57
Execute	EXECUTE	Executes a previously created form.	58
Expanded Print	EXPAND	Expands fonts vertically and horizontally.	68
Font	FONT	Selects a specific typeface: bold, slant (italic) factor, and	69
		symbol set.
Ignore Sequence	IGON	Enables the IGP to ignore all characters after the Ignore	71
On/Off	IGOFF	Sequence On command is sent until the Ignore Sequence Off
		command is sent. See note on page 20.
Line Spacing,	LPI	Defines the lines per inch (lpi) printing format.	71
Vertical
Listen	LISTEN	Removes IGP from the quiet state and enables IGP operation.	74
Multinational	ISET	Use a character set.	Chap. 5
Character Set	USET	Create a custom user-defined character set.
Normal Mode	NORMAL	Places the IGP in the Normal Mode, where it does not change	78
		the data stream but awaits the SFCC followed by an IGP
		command.
Paper Instruction	EN-PI	Enables or disables use of the PI line with a parallel interface.	80
Enable/Disable	DIS-PI
Paper Instruction	PION	Enables or disables Data Bit 8 as the paper instruction signal in	79
On/Off for Data Bit 8	PIOFF	a serial interface.
Print File	PRINT	Prints a file from the flash memory.	80
Quiet	QUIET	IGP operation is disabled until a Listen command is received.	81
		Any data sent to the line matrix printer emulation is unaffected
		by IGP commands.
Recall	RECALL	Recalls forms or logos from memory stored in “setup.ptx”.	81
Reset	RESET	Deletes all forms and logos from the IGP memory.	82

17