Zebra Technologies 14080100200, XI4TM Printer Parameters Sheet 2, Adjust the Tear-Off Position

92

Configuration

Standard Control Panel Parameters

Table 8 • Printer Parameters (Sheet 2 of 22)

Language/Parameter Action/Explanation

Adjust the Tear-Off Position

This parameter establishes the position of the media over the tear-off/peel-off bar after printing.

See Figure 14. Higher numbers move the media out (the tear line moves closer to the leading edge of the next label), and lower numbers move the media in (the tear line moves closer to the edge of the label just printed).

Figure 14 • Tear-Off Position Adjustment

1

2

1Media direction

2Factory-set tear line location at position 00

Default Value: 0

Range: -120 to +120

To change the value shown:

1.Press PLUS (+) to increase the value. Each press adjusts the tear-off position by four dot rows.

2.Press MINUS (-)to decrease the value. Each press adjusts the tear-off position by four dot rows.

Select Print Mode

This parameter tells the printer how printed labels will be removed. Make sure that you select a print mode that is compatible with your printer and printer options. For information about how the print modes work with different printer options, see Print Modes and Printer Options on page 36.

Default Value (non-RFID printers): TEAR-OFF

Default Value (RFID printers): RFID MODE

Selections: TEAR-OFF, PEEL-OFF, CUTTER, DELAYED CUT, RFID

MODE, REWIND

Note • RFID MODE should only be used with RFID media on

RFID printers.

To change the value shown:

1.Press PLUS (+) or MINUS (-)to scroll through the options.

P1009874-002 Xi4™/RXi4™ User Guide 1/7/10