Zebra Technologies 17080100000, RXI4TM manual 110, Printer Parameters Sheet 20, Set Reprint Mode

110

Configuration

Standard Control Panel Parameters

Table 8 • Printer Parameters (Sheet 20 of 22)

	Language/Parameter	Action/Explanation
		Set Reprint Mode
		When reprint mode is enabled, you can reprint the last label printed either
		by issuing the ~PR ZPL command or by pressing MINUS (-)on the control
		panel.
		Default Value: DISABLED
		Selections: ENABLED, DISABLED
		To change the value shown:
		1. Press PLUS (+) or MINUS (-)to toggle between the options.
See next column		View Sensor Settings
		These parameters are automatically set during the calibration procedure
		and should be changed only by a qualified service technician. Refer to the
		Programming Guide for ZPL, ZBI, Set-Get-Do, Mirror, and WML for
		information on these parameters.

To skip these parameters:

1.Press NEXT/SAVE to skip each of the following parameters:

P1009874-002 Xi4™/RXi4™ User Guide 1/7/10