Zebra Technologies 17080100000 Printer Parameters Sheet 7, Set Printhead Life for Early Warning

Configuration

Standard Control Panel Parameters

Table 8 • Printer Parameters (Sheet 7 of 22)

Language/Parameter Action/Explanation

Set Printhead Life for Early Warning

This parameter appears only when Early Warning for Maintenance is enabled. Set this value to the number of inches of media that the printhead is expected to print.

Default Value: 1,000,000 inches

Range: 100 to 1,000,000 inches

To change the value shown:

1.Press MINUS (-)to move the cursor.

2.Press PLUS (+) to increase the value of the digit.

When the printhead reaches the set length, WARNING REPLACE HEAD appears on the LCD. If the alert function is enabled, the printer generates an alert.

Reset Printhead Life Counter for Early Warning

This parameter appears only when Early Warning for Maintenance is enabled.

To reset the printhead life counter:

1.Did you replace the printhead?

•If you replaced the printhead, press PLUS (+) to select YES.

•If you did not replace the printhead, press MINUS (-)to select NO.

View Non-Resettable Counter

This parameter displays the total length of media that the printer has printed. You can use firmware commands to change the unit of measure and reset this counter. Refer to the Programming Guide for the printer language being used.

View User-Controlled Counter 1

This parameter displays the total length of media that the printer has printed since this parameter was last reset. You can use firmware commands to change the unit of measure and reset this counter. Refer to the Programming Guide for the printer language being used.

View User-Controlled Counter 2

This parameter displays the total length of media that the printer has printed since this parameter was last reset. You can use firmware commands to change the unit of measure and reset this counter. Refer to the Programming Guide for the printer language being used.

97

1/7/10 Xi4™/RXi4™ User Guide P1009874-002