Zebra Technologies 22080100000, XI4TM, 14080100200 Adjust Printhead Pressure and Toggle Position

82

Operations

Adjust Printhead Pressure and Toggle Position

Adjust Printhead Pressure and Toggle Position

Print quality depends on the labels and ribbon used as well as the toggle pressure and position. Make sure that your labels and ribbon are acceptable for your application. If they are, check the toggle position and then the printhead pressure.

Toggle Position Adjustment

You may need to adjust the toggles if printing is too light on one side or if thick labels are used. If the toggle pressure is too light or uneven, the labels and ribbon may slip.

To position the toggles, complete these steps:

1.Loosen the locking nuts (1) at the top of the toggle assemblies.

1

2.Slide the toggles until they provide even pressure on the media. For extremely narrow media, position one toggle over the center of the labels, and decrease the pressure on the unused toggle.

3.Tighten the locking nuts.

P1009874-002 Xi4™/RXi4™ User Guide 1/7/10