Zebra Technologies 17280100000 Printer Parameters Sheet 19 of, Default ENABLED, Default FEED MODE

Configuration

Standard Control Panel Parameters

Table 8 • Printer Parameters (Sheet 19 of 22)

Language/Parameter Action/Explanation

Set Applicator Error Signal When Printer Pauses

When this option is enabled and the printer is paused, the printer sets the applicator error state.

Default: ENABLED

Selections: ENABLED, DISABLED

To change the value shown:

1.Press PLUS (+) or MINUS (-)to toggle between the options.

Select Start Print Signal

This parameter determines how the printer reacts to the Start Print Signal input on pin 3 of the applicator interface connector at the rear of the printer.

Caution • Start Print Signal is set by the applicator manufacturer and should not be changed unless the factory defaults have been reloaded. Please make a note of it. While other choices are valid, the printer must be returned to its designated setting for it to work properly.

Default: PULSE MODE

Selections: PULSE MODE, LEVEL MODE

•PULSE MODE—Labels print when the signal transitions from HIGH to LOW.

•LEVEL MODE—Labels print as long as the signal is asserted LOW.

To change the value shown:

1.Press PLUS (+) or MINUS (-)to toggle between the options.

Select Resynch Mode

This parameter determines how the printer reacts if the label synchronization is lost and the label top is not where expected.

Default: FEED MODE

Selections: FEED MODE, ERROR MODE

•FEED MODE—If the label top is not where expected, the printer feeds a blank label to find the label top position.

•ERROR MODE—If the label top is not where expected, the printer stops, enters Pause mode, displays the message Error Condition Feed Label, flashes the ERROR light, and asserts the Service Required signal (pin 10 on the Applicator Interface Connector).

To resynch the media to the top of the label in Error mode, press PAUSE to exit Pause mode. The ERROR light stops flashing, and the Service Required signal is deactivated. The action of the printer is determined by the Head Close configuration selection (see Select Head Close Option on page 106).

To change the value shown:

1.Press PLUS (+) or MINUS (-)to toggle between the options.

109

1/7/10 Xi4™/RXi4™ User Guide P1009874-002