Zebra Technologies RXI4TM Clean the Cutter, 130, To clean the cutter, complete these steps

130

Routine Maintenance

Cleaning Schedule and Procedures

Clean the Cutter

If the cutter is not cutting the labels cleanly or if it jams with labels, clean the cutter.

Caution • The cutter blade is sharp. Do not touch or rub the blade with your fingers.

To clean the cutter, complete these steps:

1.Caution • Turn off (O) the printer and disconnect it from the power source before performing the following procedure.

Turn off (O) the printer, and disconnect the AC power cord and all data cables.

2.Using the swab from the Preventive Maintenance Kit (part number 47362), clean the stationary cutter blade. In place of the Preventive Maintenance Kit, you may use a clean swab dipped in a solution of isopropyl alcohol (minimum 90%) and deionized water (maximum 10%). Allow the solvent to evaporate.

3.If cleaning does not remove label fragments and adhesive, contact an authorized service technician.

4.Reconnect the data cables and AC power cord, and turn on (l) the printer.

P1009874-002 Xi4™/RXi4™ User Guide 1/7/10