Zebra Technologies 14080100000, XI4TM To set up the printer in Rewind mode, complete these steps

Operations

Load Media in Rewind Mode

61

Caution • While performing any tasks near an open printhead, remove all rings, watches, hanging necklaces, identification badges, or other metallic objects that could touch the printhead. You are not required to turn off the printer power when working near an open printhead, but Zebra recommends it as a precaution. If you turn off the power, you will lose all temporary settings, such as label formats, and you must reload them before you resume printing.

To set up the printer in Rewind mode, complete these steps:

1.Remove the rewind plate from its storage location inside the printer.

2.Position the rewind plate so that the lip on the attached hook plate points down.

3

1
2	4
	5

1Upper slot

2Lower slot

3Rewind plate

4Lip

5Adjustable hook plate

3.Insert the hook plate lip 1/2 in. (13 mm) into the lower slot in the side plate.

4.Align the upper end of the rewind plate with the matching upper slot in the side plate.

5.Slide in the rewind plate until it stops against the printer’s main frame.

6.Set the printer to Rewind mode. See Select Print Mode on page 92 for instructions.

1/7/10 Xi4™/RXi4™ User Guide P1009874-002