Zebra Technologies RXI4TM, 14080100200, 17080100200 manual Connect the Printer to a Power Source

28

Printer Setup

Connect the Printer to a Power Source

Connect the Printer to a Power Source

The AC power cord must have a three-prong female connector on one end that plugs into the mating AC power connector at the rear of the printer. If a power cable was not included with your printer, refer to Power Cord Specifications on page 29.

Caution • For personnel and equipment safety, always use an approved three-conductor power cord specific to the region or country intended for installation. This cord must use an IEC 320 female connector and the appropriate region-specific three-conductor grounded plug configuration.

To connect the printer to a power source, complete these steps:

1.Toggle the printer power switch to the off (O) position.

2.Plug the power cord into the AC power connector (1) on the rear of the printer.

1

3.Plug the other end of the power cord into a power outlet near the printer.

4.Turn on (I) the printer.

The control panel LCD and lights activate, indicating that the printer is booting up.

P1009874-002 Xi4™/RXi4™ User Guide 1/7/10