JAI operation manual CV-M10BX, Locations and Functions

Page 5

CV-M10BX/CV-M10RS

4. Locations and Functions

1

2

9

3 5 6

CV-M10BX

4 8 7

1.Lens mount of C-mount type. *1)

2.Interline-transfer CCD sensor with on-chip micro lenses.

3.Video output 1. VS 1.0 Vp-p. *2)

4.Video output 2. VS 1.0 Vp-p. (Only in 2 :1 interlaced mode.) *2)

5.SW1 switch on the rear panel to set the shutter speed and other function modes.

6.6 pin connector for RS 232C signals, input of external trigger pulse and WEN output.

7.12 pin connector for DC +12V power external sync signals and output of video 2

8.GAIN potmeter for adjusting level of video 1. (Min. gain is fully clockwise.)

9.Tripod mount plate to place the camera on tripod.

*1) Note: Rear protrusion on C-mount lens must be less than 10.0mm (0.4 inch approx.) When IR cut filter is used, it must be less than 7.0 mm (0.28 inch approx.) The IR cut filter is placed in the C-mount thread.

The C-mount 25 mm IR cut filter must be ordered separately.

*2) Note: In 2:1 interlace mode the 2 fields are read out simultaneously on video 1 and video 2. Each output is a normal interlaced video signal, which can be monitored on a normal video monitor. A full progressive scanned frame can be obtained by combining the 2 outputs in a frame grabber.

- 2 -

Image 5
Contents CV-M10 Declaration of Conformity Table of Contents Standard Composition Main FeaturesGeneral Locations and Functions CV-M10BXPin Assignment Pin Multi-connector DC-IN/SYNCPin Multi-connector RS 232C/TRIGGER Input of External HD/VD signals Input/Output of HD/VD SignalOutput of Internal HD/VD signals Functions and OperationPulse Width Control Trigger Mode External Trigger ModeEdge Pre-select Trigger Mode Pre-select 7HD14HD Mode Setting by Switch Mode SettingsTrigger select Scanning ModeShutter Time select CV-M10RS Serial Interface for Controls Gamma CorrectionGain Control/RS 232C control Jumper settings Location of Jumper on PK8187A Locations of JumperLocation of Jumper on PK8189A Location of Jumper for CV-M10RS on PK8190A Location of Jumper for CV-M10BX on PK8206APotentiometer locations on PK8206A Internal adjustments on BXCV-M10RS Camera Control Tool Levels Window Files and Camera Communication Window 140.57 700 Typical CCD Characteristics PrecautionsAppendix ReferencesIndex User’s RecordCamera type Revision Revision F Serial No2700- 11052 E F3