JAI Location of Jumper for CV-M10BX on PK8206A, Location of Jumper for CV-M10RS on PK8190A

Page 16

CV-M10BX/CV-M10RS

8.6.3. Location of Jumper for CV-M10BX on PK8206A

Jumpers for selecting random trigger modes for CV-M10BX. It is edge pre-select, pulse width control, H reset and H non- reset.

Jumper for trigger input 75 ohm termination is also found here.

JP10

JP13 JP12

8.6.4. Location of Jumper for CV-M10RS on PK8190A

Jumpers for selecting random trigger modes for CV-M10RS. It is edge pre-select, pulse width control, H reset and H non- reset. These modes can not be selected by RS232C.

Jumper for trigger input 75 ohm termination is also found here.

JP12

JP10 JP13

- 13 -

Image 16

Contents CV-M10 Declaration of Conformity Table of Contents General Main FeaturesStandard Composition CV-M10BX Locations and FunctionsPin Multi-connector RS 232C/TRIGGER Pin Multi-connector DC-IN/SYNCPin Assignment Input/Output of HD/VD Signal Input of External HD/VD signalsOutput of Internal HD/VD signals Functions and OperationEdge Pre-select Trigger Mode External Trigger ModePulse Width Control Trigger Mode 7HD Pre-select14HD Mode Settings Mode Setting by SwitchShutter Time select Scanning ModeTrigger select Gain Control/RS 232C control Gamma CorrectionCV-M10RS Serial Interface for Controls Jumper settings Location of Jumper on PK8189A Locations of JumperLocation of Jumper on PK8187A Location of Jumper for CV-M10BX on PK8206A Location of Jumper for CV-M10RS on PK8190AInternal adjustments on BX Potentiometer locations on PK8206ACV-M10RS Camera Control Tool Levels Window Files and Camera Communication Window 140.57 700 Precautions Typical CCD CharacteristicsAppendix ReferencesUser’s Record IndexCamera type Revision Revision F Serial No2700- 11052 E F3