JAI CV-M10 operation manual Appendix, Precautions, Typical CCD Characteristics, References

Page 22

CV-M10BX/CV-M10RS

13. Appendix

13.1. Precautions

Personnel not trained in dealing with similar electronic devices should not service this camera.

The camera contains components sensitive to electrostatic discharge. The handling of these devices should follow the requirements of electrostatic sensitive components.

Do not attempt to disassemble this camera.

Do not expose this camera to rain or moisture.

Do not face this camera towards the sun, extreme bright light or light reflecting objects.

When this camera is not in use, put the supplied lens cap on the lens mount.

Handle this camera with the maximum care.

Operate this camera only from the type of power source indicated on the camera.

Power off the camera during any modification such as changes of jumper and switch setting.

13.2. Typical CCD Characteristics

The following effects may be observed on the video monitor screen. They do not indicate any fault of the CCD camera, but do associate with typical CCD characteristics.

V. Smear

Due to an excessive bright object such as electric lighting, sun or strong reflection, vertical smear may be visible on the video monitor screen. This phenomenon is related to the characteristics of the Interline Transfer System employed in the CCD.

V. Aliasing

When the CCD camera captures stripes, straight lines or similar sharp patterns, jagged image on the monitor may appear.

Blemishes

Some pixel defects can occur, but this does not have en effect on the practical operation.

Patterned Noise

When the CCD camera captures a dark object at high temperature or is used for long time integration, fixed pattern noise (shown as white dots) may appear on the video monitor screen.

13.3. References

1.This manual can and datasheet for CV-M10 can be downloaded from www.jai.com

2.Camera control software can be downloaded from www.jai.com

3.Specifications for the EIA CCD sensor ICX 074AL can be found on www.jai.com

4.Specifications for the CCIR CCD sensor ICX 075AL can be found on www.jai.com

- 19 -

Image 22
Contents CV-M10 Declaration of Conformity Table of Contents General Main FeaturesStandard Composition CV-M10BX Locations and FunctionsPin Multi-connector RS 232C/TRIGGER Pin Multi-connector DC-IN/SYNCPin Assignment Output of Internal HD/VD signals Input/Output of HD/VD SignalInput of External HD/VD signals Functions and OperationEdge Pre-select Trigger Mode External Trigger ModePulse Width Control Trigger Mode 7HD Pre-select14HD Mode Settings Mode Setting by SwitchShutter Time select Scanning ModeTrigger select Gain Control/RS 232C control Gamma CorrectionCV-M10RS Serial Interface for Controls Jumper settings Location of Jumper on PK8189A Locations of JumperLocation of Jumper on PK8187A Location of Jumper for CV-M10BX on PK8206A Location of Jumper for CV-M10RS on PK8190AInternal adjustments on BX Potentiometer locations on PK8206ACV-M10RS Camera Control Tool Levels Window Files and Camera Communication Window 140.57 700 Appendix PrecautionsTypical CCD Characteristics ReferencesCamera type User’s RecordIndex Revision Revision F Serial No2700- 11052 E F3