JAI CV-A33CL operation manual Configuring the Camera, Other Functions, Switch setting inside

Page 19

CV-A33CL

6.5. Other Functions.

User ID.

The command (UD) the user can save up to 16 characters in the camera to identify the camera.

Bit Allocation.

The command (BA) will select the number of bits in the Camera Link output to 8 or 10 bit.

Black Level.

The command (BL) is for adjusting the video black level (or set-up level).

GAin level.

The command (GA) is for adjusting the gain level between 0 and 15 dB.

CaliBration of CMOS sensor.

This command (CB=0) will calibrate all the A/D converters on the CMOS sensor. The calibration procedure for gain and offset is done automatically each time the command is received and at power up. Allow the camera to warm up before the calibration is done.

The data from the calibration can be stored in a file by the camera control tool by the command “Read Calibration” and “Write to File”. With the command “Read from File” the calibration data can be loaded to the camera and used as calibration.

Important notes on using this function.

•“Read Calibration” takes about 22 seconds.

•“Read from File” takes about 45 seconds.

7.Configuring the Camera

7.1. Switch setting inside

SW 200 is for selecting the RS232C input through Camera Link or the 12 pin HR connector. SW 200 is placed inside on the camera motherboard PK8387B near the rear.

SW 300 is for 75 Ω terminating of the trigger input on pin #10 on 12 pin HR connector. SW 300 is placed inside on the rear board PK8388B. (On for 75 Ω terminating.)

SW 200

OnOff

CL HR

SW 300

On

Off

1 2

Trig. Pin #10

Fig. 24. Internal switch setting

- 18 -

Page 18 Page 20
Image 19
Page 18 Page 20
Contents CV-A33CL CV-A33CL General Main FeaturesStandard Composition Locations Locations and FunctionsDigital Output Connector for Camera Link Pin Multi-connector DC-IN/TriggerPin Assignment EEN output Input and Output CircuitsCV-A33 Camera Camera Link Cable Camera Link interfacePixel principle Functions and OperationsBasic functions Cmos SensorColumn Process Cmos Sensor principle diagramCV-A33 Cmos Sensor array Auto Trigger Window of Interest Window of InterestHorizontal timing Normal mode. Full frame Sensor layout and timingEffective image format Vertical timing Normal mode. Full frameLval a-synchronous accumulation Lval a-synchronous accumulationWindow of interest Timing for window of interestTrigger Modes Input/Output of Timing SignalsInput of Timing Signals Output of Timing SignalsContinuous Operation Non triggered Edge Pre-select ModeVertical timing for edge pre-select min. exposure Vertical timing for pulse width control min. exposure Pulse Width Control ModeVertical timing for auto trigger function Auto trigger ModeSwitch setting inside Configuring the CameraOther Functions RS-232C control Parameter Remarks CV-A33CL command listWindow from camera control tool Camera Control Tool for CV-A33Specifications External Appearance and DimensionsSpectral sensitivity CV-A33CL Specification tableTypical Sensor Characteristics PrecautionsAppendix Users Record Users Mode Settings Users ModificationsCamera type
Top Page Image Contents