JAI CV-A33CL operation manual Pin Assignment, Pin Multi-connector DC-IN/Trigger

Page 5

CV-A33CL

5. Pin Assignment

5.1. 12-pin Multi-connector (DC-IN/Trigger)

Type: HR10A-10R-12PB-01 (Hirose) male.

(Seen from rear of camera.)

19

2 10 8

3 11 12 7

46

5

Fig. 2. 12-pin connector.

Pin no.	Signal		Remarks
1	GND
2	+12 V DC input
3	GND
4	N/C
5	GND
6	RXD in		RS 232C. Or via Camera Link by internal
7	TXD out		SW200 on PK8378A (Off=HR)
8	GND
9	EEN out		And via Camera Link
10	Trigger input		Or via Camera Link. (TI=1 for HR) *)
11	N/C
12	GND

*) Internal SW300-1 on rear board for 75 Ω terminations. Refer to 7.1. Inside switch settings.

5.2. Digital Output Connector for Camera Link

13							1



26							14

Type: 26 pin MRD connector 3M 10226-1A10JL

Fig. 3. Camera Link connector

The digital output signals follow the Camera Link standardized multiplexed signal output interface. Camera Link base configuration is used. The interface circuit is build around the NS type DS90CR285MTD.

The following signals are found on the Digital Output Connector:

SerTC	RXD serial data to camera	(Or via 12 pin HR by internal SW200.
SerTFG	TXD serial data to frame grabber	On for CL)
CC1	Trigger input	(Or on 12 pin HR. TI=0 for CL)
CC2	Factory use
X0 to X3	Camera Link multiplexed data out
Xclk	Camera Link clock. Used as pixel clock.
In the Channel Link X0 to X3 multiplexed signals the following signals are encoded.
D0 – D9	2 x 8/10 bit video data out.
LVAL	Line VALid. Video line data is valid. High for valid line.
FVAL	Frame VALid. Video frame data is valid. High for valid frame.
DVAL	Data VALid. Effective video pixel data is valid. High for valid data.
EEN	Exposure ENable. High during exposure.

The polarity is positive and TRIG in negative as factory setting.

For Camera Link interface principle diagram please check Fig. 7.

- 4 -

Image 5

Contents CV-A33CL CV-A33CL Standard Composition Main FeaturesGeneral Locations Locations and FunctionsPin Assignment Pin Multi-connector DC-IN/TriggerDigital Output Connector for Camera Link EEN output Input and Output CircuitsCV-A33 Camera Camera Link Cable Camera Link interfaceBasic functions Functions and OperationsCmos Sensor Pixel principleCV-A33 Cmos Sensor array Cmos Sensor principle diagramColumn Process Auto Trigger Window of Interest Window of InterestEffective image format Sensor layout and timingVertical timing Normal mode. Full frame Horizontal timing Normal mode. Full frameLval a-synchronous accumulation Lval a-synchronous accumulationWindow of interest Timing for window of interestInput of Timing Signals Input/Output of Timing SignalsOutput of Timing Signals Trigger ModesContinuous Operation Non triggered Edge Pre-select ModeVertical timing for edge pre-select min. exposure Vertical timing for pulse width control min. exposure Pulse Width Control ModeVertical timing for auto trigger function Auto trigger ModeOther Functions Configuring the CameraSwitch setting inside RS-232C control Parameter Remarks CV-A33CL command listWindow from camera control tool Camera Control Tool for CV-A33Spectral sensitivity External Appearance and DimensionsSpecifications CV-A33CL Specification tableAppendix PrecautionsTypical Sensor Characteristics Camera type Users Mode Settings Users ModificationsUsers Record