JAI CV-M539, CV-M536 Location of SW2 and Jumpers, Board PK8054 Side B, Board PK8057 Side a

Page 19

CV-M536/538/539

7.4. Location of SW2 and Jumpers

Jumpers are shorted with a 0 Ohm resistor or by a soldering between the 2 points. To remove the solder tin from a jumper position, use a special tin remover such as de-soldering wick.

7.4.1. Board PK8054 Side B

JP10R127JP2

JP1SW2

JP6JP7

7.4.2. Board PK8057 Side A

JP9

JP11JP3

JP5JP8

- 18 -

Image 19

Contents CV-M536/538/539 Declaration of Conformity Table of Contents Standard Composition GeneralMain Features Locations and Functions Pin Multi-connector Trigger Pin Multi-connector DC-IN/SYNCPin Assignment Functions and Operations Input/Output of HD/VD SignalEdge pre-select mode for non-interlace only EIA Non-interlaced / Field accumulation modePulse Width Control Mode Ccir Non-interlaced / Field accumulation modePulse width control mode for non-interlace only Start/Stop Trigger Mode CV-M536/538/539 EIA Ccir Long Time Exposure ModeCV-M536/538/539 Table for SW 1 Setting Mode Setting Table for Shutter Time SW2 on PK8057 Board Pixel Clock Output Jumper SettingsBoard PK8054 Side B Location of SW2 and JumpersBoard PK8057 Side a Adjustment of Video Signal Output Level CCU External AppearanceHead Spectral Sensitivity SpecificationsTypical CCD Characteristics PrecautionsAppendix Revision Revision E Serial No Users Mode Settings Users ModificationsUser’s Record Camera type CV-M536/538/539 Scanning system