JAI CV-M539, CV-M538 operation manual CV-M536/538/539

Page 15

CV-M536/538/539

Cautions in the Long Time Exposure Mode.

1.Theoretical exposure time is as follows. EIA: 1/30 sec. to . CCIR: 1/25 sec. to .

2.It is recommended not to use exposure >2 sec. since visible dark-current noise may occur.

3.Ext. HD signal (4.0 Vp-p ± 2.0V at 75 Ohm terminated) has to be input continuously The falling edge of Int. HD signal and Ext. VD signal are phase-synchronized.

4.Timing of ext. VD signal in each accumulation mode has to be set, as described before.

a)2:1 Interlaced mode (Field accumulation mode)

b) 2:1 Interlaced mode (Frame accumulation mode)

c) Non interlaced mode (Field accumulation mode)

- 14 -

Image 15
Contents CV-M536/538/539 Declaration of Conformity Table of Contents Standard Composition GeneralMain Features Locations and Functions Pin Multi-connector DC-IN/SYNC Pin Multi-connector TriggerPin Assignment Functions and Operations Input/Output of HD/VD SignalEdge pre-select mode for non-interlace only EIA Non-interlaced / Field accumulation modePulse Width Control Mode Ccir Non-interlaced / Field accumulation modePulse width control mode for non-interlace only Start/Stop Trigger Mode CV-M536/538/539 EIA Ccir Long Time Exposure ModeCV-M536/538/539 Mode Setting Table for SW 1 SettingTable for Shutter Time SW2 on PK8057 Board Pixel Clock Output Jumper SettingsLocation of SW2 and Jumpers Board PK8054 Side BBoard PK8057 Side a Adjustment of Video Signal Output Level External Appearance CCUHead Spectral Sensitivity SpecificationsPrecautions Typical CCD CharacteristicsAppendix Revision Revision E Serial No Users Mode Settings Users ModificationsUser’s Record Camera type CV-M536/538/539 Scanning system