Hasselblad H4D200MS user manual  CARRYING Strap,  RECHARGEABLE Battery Grip,  BATTERY Charger

 CARRYING STRAP

The carrying strap is attached by firstly withdrawing the safety collar. The hook is then freed and can be attached to the strap lug. Slide back the safety collar to ensure the hook remains in the locked position between the small protruding lugs. The collar is purposely a tight fit to avoid unintention- ally slipping back and therefore might need some effort to slide.

 RECHARGEABLE BATTERY GRIP

The environmentally approved­ Battery grip Li-ion(3043356) is the standard power source for the H5D camera. The H5D requires a power supply for all actions as there is no me- chanical reserve facility. When working untethered, it is therefore advisable to keep a reserve rechargeable battery grip at hand. As is the case with most batteries, problems might be encountered when used in very low temperatures. In this situation it is advisable to keep the reserve battery in an inside pocket, for example, to maintain it near body temperature (both sorts of battery grips are referred to as the ‘battery’ in this manual).

 FITTING AND REMOVING A BATTERY

The fitting and removing procedure is the same for both types of battery grip.

Remove the battery from the camera by depressing the bat- tery holder button (A) and simultaneously swinging the bat- tery holder retaining lever (B) down until it stops. Pull the battery downwards (C).

If you intend to store the battery separately from the camera you should ensure that the safety cover is in place (to pre- vent short-circuiting). It snaps into place and is removed by pulling outwards and upwards on the locking clip.

C

A

B

To fit, hold the battery flat against the camera body and aligning the two upper lugs with the slot, slide it back into position as far as it will go. Swing back the battery holder retaining lever until it clicks back into place.

 BATTERY CHARGER

The battery charger is supplied with a number of plug at- tachments to suit various types of domestic electrical sock- ets available worldwide. Other types of socket will require a domestic socket converter.

Attach the chosen plug by sliding it into position as in the diagram. Removal is by the reverse procedure.

Please note that the Battery charger Li-ion 2900 (3053572) is designed for use with Battery grip Li-ion 2900 (3043356) but can also be used together with the Battery grip re- chargeable 7.2V Li-Ion(3043348) intended for H4D use.

Likewise, the older Battery charger for Li-Ion battery (3053568) also can also be used together with the Battery grip Li-ion 2900 (3043356) but requires 50% longer charg- ing times.

20