EverFocus EZN850 user manual Event

Page 40

EZN850

4.6 EVENT

An event in the camera is when an Event Type is activated and causes certain actions to be performed. The event type is the set of conditions that specifies how and when which actions will be performed.

This table describes how to setup action types and event type.

Event Type		Manual	Motion	Schedule
Action Type	Alarm Input	Trigger	Detection	Recording	Pre/Post-Alarm
Trigger Alarm	x	x	x
Send Mail notification	x	x	x
Upload to FTP**	x	x	x		x
Record to SD Card	x	x	x	x	x
Record to PC*	x	x	x	x	x
Network Alarm	x	x	x
Re-trigger	x	x	x

Note: 1. * Record to PC only works when PC and IP camera are connected.

2.**Either Upload to FTP or Record to Network Storage can be selected to record event video to remote site.

3.Up to 10 event types can be configured in the camera, and up to 3 of these can be configured to upload images.

40

Image 40

Contents EZN850 User’s Manual EZN850 Safety Notice EZN850 About this documentTerms and Trademark SupportTable of Contents Introduction Accessing the Camera Menu EZN850 Setting EZN850 System Info InformationEZN850 2 Log User Config EZN850 Network NetworkIP Type IP addressSubnet Mask GatewayHttp Port EZN850 PasswordDdns Bandwidth SMTP/FTP EZN850 EZN850 Network Alarm reserved for PowerCon VideoEZN850 Multi Streaming Camera Lens ControlOSD setting LensShutter ESC Reserved White Balance ControlBacklight AGC Auto Gain Control DNR Dynamic Noise ReductionSENS-UP Special M E R a I D C D E F G H L M P Q R S T U V W X Y Z Motion Detection AREA1 AREA2 AREA3 AREA4 EZN850 Color ADJ Aerea SEL AREA1 Sync INT Area State OFF EZN850 Special Camera ID OFF Color ADJ Sync INT Motiion DET Privacy Exit User Event EZN850 Event EZN850 Motion Alarm EZN850 EZN850 Time Mask System Date/TimeEZN850 EZN850 Daylight Saving SD Card EZN850 EZN850 EZN850 Serial Communication Maintenance EZN850 Specifications Environmental Head Office USA L.A. Office USA N.Y. Office Europe OfficeChina Office Japan Office