EverFocus EZN850 user manual

Page 48

EZN850

Time: Click on Hour, Minute, Seconds, am/pm; then use up arrow to increase value and down arrow to decrease value.

Press Apply to apply the setting changes or Reset to reset without saving the change.

Set Date/Time Sync.

Check Enable NTP checkbox to enable NTP server.

NTP server: Time automatically adjusted by synchronizing with NTP server will be used as the standard time of the camera.

Sync. Internal: Select an interval (1 - 24 hours: in 1 hour intervals) of synchronization with the NTP server.

Time Zone: Select a time zone according to the location where the camera is in use.

Press Apply to apply the setting changes or Reset to reset without saving the change.

48

Image 48

Contents EZN850 User’s Manual EZN850 Safety Notice EZN850 About this documentTerms and Trademark SupportTable of Contents Introduction Accessing the Camera Menu EZN850 Setting EZN850 System Info InformationEZN850 2 Log User Config EZN850 Network NetworkIP Type IP addressSubnet Mask GatewayEZN850 Password Http PortDdns Bandwidth SMTP/FTP EZN850 EZN850 Network Alarm reserved for PowerCon VideoEZN850 Multi Streaming Camera Lens ControlOSD setting LensShutter ESC Reserved White Balance ControlBacklight AGC Auto Gain Control DNR Dynamic Noise ReductionSENS-UP Special M E R a I D C D E F G H L M P Q R S T U V W X Y Z Motion Detection AREA1 AREA2 AREA3 AREA4 EZN850 Color ADJ Aerea SEL AREA1 Sync INT Area State OFF EZN850 Special Camera ID OFF Color ADJ Sync INT Motiion DET Privacy Exit User Event EZN850 Event EZN850 Motion Alarm EZN850 EZN850 Time Mask System Date/TimeEZN850 EZN850 Daylight Saving SD Card EZN850 EZN850 EZN850 Serial Communication Maintenance EZN850 Specifications Environmental Head Office USA L.A. Office USA N.Y. Office Europe OfficeChina Office Japan Office