EverFocus EZN850 user manual

Page 55

EZN850

Save/Load Configuration Server

To take a backup of all of the configurations, press Save to save all configurations to a config. file. If necessary, it is then possible to return to the previous settings if the settings are changed and there is unexpected behavior.

Press the Browse button to locate the saved config. file (see above) and then click the Load button. The settings will be restored to the previous configuration.

Upgrade Firmware

Upgrade the EZN850 with the latest firmware.

Press Browse button to search firmware file. Press Upgrade button to upgrade the firmware.

Note

1.Do not disconnect power to the unit during the upgrade. The unit reboots automatically after the upgrade has completed. (1-5 minutes.)

2.During upgrading process, all event recording actions will be stopped. It will continue to record after the camera is rebooted.

55

Image 55

Contents EZN850 User’s Manual EZN850 EZN850 About this document Safety NoticeSupport Terms and TrademarkTable of Contents Introduction Accessing the Camera Menu EZN850 Setting EZN850 Information System InfoEZN850 2 Log User Config EZN850 Network NetworkGateway IP TypeIP address Subnet MaskHttp Port EZN850 PasswordDdns Bandwidth SMTP/FTP EZN850 Video EZN850 Network Alarm reserved for PowerConEZN850 Multi Streaming Lens Control CameraLens OSD settingShutter White Balance Control ESC ReservedBacklight DNR Dynamic Noise Reduction AGC Auto Gain ControlSENS-UP Special M E R a I D C D E F G H L M P Q R S T U V W X Y Z Motion Detection AREA1 AREA2 AREA3 AREA4 EZN850 Color ADJ Aerea SEL AREA1 Sync INT Area State OFF EZN850 Special Camera ID OFF Color ADJ Sync INT Motiion DET Privacy Exit User Event EZN850 Event EZN850 Motion Alarm EZN850 EZN850 Time Mask Date/Time SystemEZN850 EZN850 Daylight Saving SD Card EZN850 EZN850 EZN850 Serial Communication Maintenance EZN850 Specifications Environmental Japan Office Head OfficeUSA L.A. Office USA N.Y. Office Europe Office China Office