EverFocus EZN850 user manual Maintenance

Page 54

EZN850

Press Apply to apply the setting changes or Reset to reset without saving the change.

4.7.5 Maintenance

Maintenance Server

Reboot: The unit is rebooted without changing any of the settings. Use this method by pressing Reboot button if the unit is not behaving as expected.

Restore: The unit is restarted and most current settings are reset to the factory default values by pressing Restore button. The only settings saved are:

•IP setting

•DDNS setting

Default: The Default button should be used with caution. Pressing this button will return all of the camera's settings, including the IP address, to the factory default values. The camera will then have to be re-installed.

54

Image 54

Contents EZN850 User’s Manual EZN850 Safety Notice EZN850 About this documentTerms and Trademark SupportTable of Contents Introduction Accessing the Camera Menu EZN850 Setting EZN850 System Info InformationEZN850 2 Log User Config EZN850 Network NetworkSubnet Mask IP TypeIP address GatewayEZN850 Password Http PortDdns Bandwidth SMTP/FTP EZN850 EZN850 Network Alarm reserved for PowerCon VideoEZN850 Multi Streaming Camera Lens ControlOSD setting LensShutter ESC Reserved White Balance ControlBacklight AGC Auto Gain Control DNR Dynamic Noise ReductionSENS-UP Special M E R a I D C D E F G H L M P Q R S T U V W X Y Z Motion Detection AREA1 AREA2 AREA3 AREA4 EZN850 Color ADJ Aerea SEL AREA1 Sync INT Area State OFF EZN850 Special Camera ID OFF Color ADJ Sync INT Motiion DET Privacy Exit User Event EZN850 Event EZN850 Motion Alarm EZN850 EZN850 Time Mask System Date/TimeEZN850 EZN850 Daylight Saving SD Card EZN850 EZN850 EZN850 Serial Communication Maintenance EZN850 Specifications Environmental China Office Head OfficeUSA L.A. Office USA N.Y. Office Europe Office Japan Office