EverFocus EZN850 user manual Motion

Page 43

EZN850

5.Check “Enable Pre-alarm Buffer” and “Enable Post-alarm Buffer”. For pre-and post alarm buffer setting, please refer to “4.6.3 Alarm”.

6.Check “Enable This Event”.

7.Select “Always” for time mask. For detail about Time Mask, please refer to “4.6.4 Time Mask”.

8.Click to save this event in event list.

4.6.2Motion

Motion Detection

User can define the motion area to be detected by left clicking the mouse to draw lines. Every click is an end point of the line. When the detection area is formed, double click the mouse to have all the lines connected. To remove the selection, simply right click the mouse, the selected polygon will be deleted.

Steps for setting motion detection areas:

1.Motion Detection video is not a moving video. For getting the most update

picture, press to update the current image.

43

Image 43

Contents EZN850 User’s Manual EZN850 EZN850 About this document Safety NoticeSupport Terms and TrademarkTable of Contents Introduction Accessing the Camera Menu EZN850 Setting EZN850 Information System InfoEZN850 2 Log User Config EZN850 Network NetworkGateway IP TypeIP address Subnet MaskHttp Port EZN850 PasswordDdns Bandwidth SMTP/FTP EZN850 Video EZN850 Network Alarm reserved for PowerConEZN850 Multi Streaming Lens Control CameraLens OSD settingShutter White Balance Control ESC ReservedBacklight DNR Dynamic Noise Reduction AGC Auto Gain ControlSENS-UP Special M E R a I D C D E F G H L M P Q R S T U V W X Y Z Motion Detection AREA1 AREA2 AREA3 AREA4 EZN850 Color ADJ Aerea SEL AREA1 Sync INT Area State OFF EZN850 Special Camera ID OFF Color ADJ Sync INT Motiion DET Privacy Exit User Event EZN850 Event EZN850 Motion Alarm EZN850 EZN850 Time Mask Date/Time SystemEZN850 EZN850 Daylight Saving SD Card EZN850 EZN850 EZN850 Serial Communication Maintenance EZN850 Specifications Environmental Japan Office Head OfficeUSA L.A. Office USA N.Y. Office Europe Office China Office