Condensation

4.Places subject to strong vibrations.

5.Places affected by smoke of steam.

6.Places subject to strong magnetic fields (such as near motors, transformers or near magnets).

7.For long periods in contact with chemicals such as pesticides or next to rubber or vinyl products.

8.Digital cameras like the ix-10 are particularly badly affected by sand. In sandy locations such as beaches or deserts, or in locations where there is wind-borne sand, ensure that the camera is protected. This can cause faults that may be irreparable.

♦If the camera is carried suddenly from a cold location into a warm place, water droplets (condensation) may form on the inside of the camera or on the lens. When this occurs, switch the camera off and wait an hour before using the camera. Condensation may also form on the SmartMedia card. In this event, remove the SmartMedia card and wait a short time before using it again.

Cleaning Your Camera

♦Use a blower brush to remove dust from the lens and camera surface and then wipe lightly with a soft, dry cloth. If any soiling remains, apply a small amount of lens cleaning liquid to a piece of soft tissue and wipe gently.

♦Do not scratch hard objects against the lens, data panel or viewfinder as these surfaces are easily damaged.

♦Clean the body of the camera with a soft, dry, cloth. Do not use volatile substances such as thinners, benzene or insecticide, as these may react with the camera body and cause damage.

General Information

♦Do not use the camera while you are walking, running, driving or operating machinery. This can result in a serious accident.

♦Do not use the camera in locations severely affected by oil fumes, steam, humidity or dust. This can cause fire or electric shock.

♦Do not leave this camera in places subject to extremely high temperatures such as a sealed vehicle or in direct sunlight. This can damage the camera and in extreme cases cause fire.

♦Do not use the flash close to anyone’s eyes. This can cause temporary damage to eyesight.