Yamaha RX-V1700 owner manual 119 En, Remote control, Device Over, Hdcp Error

TROUBLESHOOTING

■Remote control

Problem	Cause	Remedy	See
			page
The remote control	Wrong distance or angle.	The remote control will function within a maximum
does not work or		range of 6 m and no more than 30 degrees off-axis	9
function properly.		from the front panel.
	Direct sunlight or lighting (from an	Reposition this unit.
	inverter type of fluorescent lamp, etc.) is		—
	striking the remote control sensor of this
	unit.
	The batteries are weak.	Replace all batteries.	9
	The operation mode selector is set	Set the operation mode selector correctly.
	incorrectly.	When operating this unit, set it to the AMP position.
		When operating the component selected by the input	—
		selector button, set it to the SOURCE position.
		When operating the TV set in the DTV or PHONO
		area, set it to the TV position.
	The remote control code was not correctly	Set the remote control code correctly using
	set.	“LIST OF REMOTE CONTROL CODES” at the end	96
		of this manual.
		Try setting another code of the same manufacturer
		using “LIST OF REMOTE CONTROL CODES” at	96
		the end of this manual.
	The library code of the remote control and	Match the remote control ID of this unit with the
	the remote control ID of this unit do not	corresponding remote control library code.	97, 111
	match.
	Even if the remote control code is	Program the necessary functions independently into
	correctly set, there are some models that	the programmable buttons using the Learn feature.	98
	do not respond to the remote control.
The remote control	The batteries of this remote control and/or	Replace the batteries.	9
does not learn new	the other remote control are too weak.
functions.
	The distance between the two remote	Place the remote controls at the proper distance.	98
	controls is too much or too little.
	The signal coding or modulation of the	Learning is not possible.
	other remote control is not compatible		—
	with this remote control.
	Memory capacity is full.	Delete other unnecessary functions to make room for	103
		the new functions.
■ HDMI

Error message	Cause	Remedy	See
			page
DEVICE OVER	The number of the connected HDMI	Reduce the number of the connected HDMI	—
	components is over the limit.	components.
HDCP ERROR	HDCP authentication failed.	Check that the connected HDMI components support	—
		the HDCP copy protection standards.

INFORMATION ADDITIONAL

English

119 En