Yamaha RX-V1700 owner manual Recording, 68 En

RECORDING

Recording adjustments and other operations are performed from the recording components. Refer to the operating instructions for those components.

CAUTION

The DTS signal is a digital bitstream. Attempting to digitally record the DTS bitstream will result in noise being recorded. Therefore, if you want to use this unit to record sources encoded in DTS, the following considerations and adjustments need to be made. To play DTS-encoded DVDs and CDs (when using a digital audio connection) on your DTS-compatible player, follow its operating instructions to make a setting so that the analog signal will be output from the player.

Notes

•When this unit is set to the standby mode, you cannot record between other components connected to this unit.

•The settings of TONE CONTROL (see page 50), VOLUME, the speaker level (see page 83) and the sound field programs (see page 45) do not affect recorded material.

•The source connected to the MULTI CH INPUT jacks of this unit cannot be recorded.

•Digital signals input at the DIGITAL INPUT jacks are not output at the analog AUDIO OUT (REC) jacks for recording. Likewise, analog signals input at the AUDIO IN jacks are not output at the DIGITAL OUTPUT jack. Therefore, if your source component is connected to provide only digital or analog signals, you can only record digital or analog signals.

•A given input source is not output on the same OUT (REC) channel.

•S-video and composite video signals pass independently through the video circuits of this unit. Therefore, when recording or dubbing video signals input from a video source component that provides only an S-video or a composite video signal, you can record only an S-video or a composite video signal on your VCR.

•The analog audio signals input at the DOCK terminal can be output at the analog AUDIO OUT (REC) jacks for recording.

•Check the copyright laws in your country to record from CDs, radio, etc. Recording of copyrighted material may infringe copyright laws.

y

Do a test recording before you start an actual recording.

If you play back a video source that uses scrambled or encoded signals to prevent it from being dubbed, the picture itself may be disturbed due to those signals.

PURE DIRECT

VOLUME

CONTROL					FM/AM	MEMORY
	A/B/C/D/E					MAN'L/AUTO FM	ENHANCER
INPUT				EDIT
	STRAIGHT				ZONE ON/OFF ZONE CONTROLS
MAIN ZONE			MULTI ZONE
	EFFECT				ZONE 2	ZONE 3
ON/OFF	YPAO	SILENT CINEMA	S VIDEO	VIDEO	L AUDIO		OPTICAL
PROGRAM	OPTIMIZER	PHONES			VIDEO AUX
	MIC
MASTER

2

	POWER	POWER	STANDBY	POWER
	TV	AV
			AUDIO SEL	SLEEP
	PHONO	TUNER	CD	MULTI CH IN
2	V-AUX/DOCK	CBL/SAT	MD/TAPE	CD-R
	DTV	VCR 1	DVR/VCR 2	DVD

1Turn on all the connected components.

2Rotate the INPUT selector on the front panel (or press one of the input selector buttons on the remote control) to select the source component you want to record from.

INPUT

PHONO TUNER CD

	or	V-AUX/DOCK CBL/SAT MD/TAPE	CD-R
		DTV VCR 1 DVR/VCR 2	DVD
Front panel		Remote control

3Start playback on the selected source component or select a broadcast station.

4Start recording on the recording component.

68 En