Operating Your Camera
Color 
B/W Change
Color | B/W Point | 3 | ||
Color | B/W Time | 5 | ||
|
|
|
|
|
|
| I |
| |
B/W | Color Time | 10 | ||
|
|
|
|
|
|
| I |
| |
BURST |
|
| OFF | |
Press SET to Return
Change the value using the LEFT or RIGHT button(1~5)
Change the value using the LEFT or RIGHT button(1~10)
Change the value using the LEFT or RIGHT button(2~20)
Operating Your Camera
Synchronization Mode
Two synchronization modes are available internal and External linelock. In linelock mode, it synchronizes the video signal between cameras without a synchronous generator. The linelock synchronization is only used in the areas of 60Hz(NTSC models)/50Hz(PAL models)
1.Press the SET button to display the setup menu and move the arrow indicator to 'Sync.' Using the UP or DOWN button.
Setup |
|
Camera ID | OFF |
Color | B/W Point : 1~5 | |
| 1 | : around 1 LUX |
| 3 | : around 3~4 LUX |
| 5 | : around 7~8 LUX |
The color changing point above is based on the AGC level to the middle. You should select the proper value depending on the condition like lens.
Color 
B/W Time : 1sec.~10sec.(1sec. term)
B/W 
Color Time : 2sec.~20sec.(1sec. term)
BURST : OFF/ON
BLC | OFF |
Lens | DC |
Shutter | OFF |
Gain | AGC |
White Balance | ATW |
Motion Detect | OFF |
Color | AUTO |
Sync. | L / L |
Reset |
|
End |
|
Select ‘L/L’ or ‘INT’ using the LEFT or RIGHT button.
EXT : The Color/ BW mode change can be controlled by an external Sensor or other equipment connected on the DN terminal (D/N IN) on the back side of camera.
Pressing the SET button at EXT mode, you can control the burst existence during the mode changing to B/W mode.
BURST : OFF/ON
DN input terminal is
Closed contact : B/W mode
Press SET button
Phase | 45 |
I
Press SET to Return
Adjust the Phase level using the LEFT or RIGHT. button(from 0 to 270°)
1.Under Gain OFF Color/BW does not change over automatically, ON/OFF is only available. 2.If you change ‘Gain’ menu OFF to AGC, ‘Color’ mode change to AUTO automatically. 3.Adjust the focus if the camera is out of focus for changing modes.
Day&Night Color CCD Camera | 32 |
When the power frequency is 60Hz, you can use linelock mode(NTSC models). When the power frequency is 50Hz, you can use linelock mode(PAL models).
33 | Day&Night Color CCD Camera |