Operating Your Camera
2. | Specify the zone area. |
| You can specify the zone area by setting a proper value from 0 to 15 with an |
| increment of 1. Move the arrow indicator to ‘Top’ using the UP or DOWN |
| button and increase or decrease the value using the LEFT or RIGHT button. |
| Repeat the procedure for bottom, left, and right. |
3. | Adjust Sensitivity |
Operating Your Camera
Color (Day & Night)
Your camera provides automatic mode changeover by sensing day or night conditions. It changes to Color mode in day conditions for optimal color and to B/W mode in night conditions for clear identification.
1.Press the SET button to display the setup menu and move the arrow indicator to ‘Color’ using the UP or DOWN button.
Move the arrow indicator to ‘Sensitivity’ using the UP or DOWN button, then |
press the LEFT or RIGHT button to decrease or increase the value. |
If you decrease the sensitivity, the camera will detect only motion that is |
clearly noticeable.If you want to set the camera to detect minor motion, |
increase the sensitivity. |
You can select the sensitivity from 0 to 15. |
Higher sensitivity detects smaller motions at the risk of false detection. |
Therefore zone adjustment is recommended rather than sensitivity adjustment. |
4. Adjust the output signal. |
POSI(Positive) : When a motion is sensed, +5V of Pulse will be output |
NEGA(Negative) : When a motion is sensed, 0V of Pulse will be output |
| Setup |
|
|
|
|
| Camera ID | OFF |
|
| |
| BLC | OFF |
|
| |
| Lens | DC |
|
| |
| Shutter | OFF |
|
| |
| Gain | AGC |
|
| |
| White Balance | ATW |
|
| |
| Motion Detect | ON |
|
| |
| Color | AUTO |
|
|
|
|
|
|
| ||
| Sync. | INT |
|
| |
| Reset |
|
|
|
|
| End |
|
|
|
|
|
|
|
|
|
|
Select the AUTO, ON, BW, EXT. using the LEFT or RIGHT button
ALARM : You can connect external equipment like buzzer or lamp. The output |
of alarm is an open collector under DC16V & 100mA capacity. |
Tips on using Motion Detection
After selecting zone and sensitivity, perform a test operation to make sure it works properly.
If the lighting flickers, the motion detection feature might not work properly. This system does not guarantee prevention of fires or thefts. The manufacturer is not responsible for any accident or damage.
Day&Night Color CCD Camera | 30 |
2.Select a mode using the LEFT or RIGHT button.
ON : Color mode is kept up.
B/W : Black and white mode is kept up.
AUTO : The mode is changed between Color and B/W automatically depending on the brightness.
Pushing the SET button at Auto mode, you can control the mode changing point and time and burst existence during the mode change to B/W mode.
31 | Day&Night Color CCD Camera |