Working with the operating menu
By way of example of the “Tune” menu, this section describes how to use the operating menu.
After switching the unit on, the standard display is shown on the display panel.
EM 300 G2 |
Transmitters |
Getting into the operating menu
Press the SET button to get from the standard display into the operating menu. The last menu selected flashes on the display. With the receiver, the current setting is additionally displayed.
Selecting a menu
Press the / buttons to select a menu.
Press the SET button to get into the setting mode of the selected menu. With the transmitters, the current setting that can be adjusted flashes on the display. With the receiver, the name of the menu and the current setting are displayed.
Adjusting a setting
Press the / buttons to adjust the setting.
By briefly pressing the / buttons, the display jumps either forwards or backwards to the next setting. In the “Channel”, “Tune” and “Name” menu, the / buttons feature a “fast search” function. If you hold down a button, the display cycles continuously. The “fast search” function allows you to get fast and easily to your desired setting. With the transmitters, the new setting flashes on the display until it is stored.
Storing a setting
Press the SET button to store the setting. “Stored” appears on the display, indicating that the setting has been stored. The display then returns to the top menu level.
With most menus, new settings become effective immediately without having to be stored. An exception are the “BANK”, “CHAN”, “TUNE” and “RESET” menus of the transmitters and the “Reset” menu of the receiver. With these menus, new settings only become effective after they have been stored and “Stored” had appeared on the display.
21