Sennheiser W300 manual Entering a name, Loading the factory-preset default settings

NAME Name

RESET Reset

PILOT

Pilot

Entering a name

Via the “Name” menu, you can enter a freely selectable name for each transmitter and receiver. You can, for example, enter the name of the performer for whom the adjustments have been made.

The name can be displayed on the standard display and can consist of up to six characters (transmitters) and up to ten characters (receiver) such as:

yletters (without pronounciation marks),

ynumbers from 0 to 9,

yspecial characters e.g. () - . _ and spaces.

To enter a name, proceed as follows:

Press the SET button to get into the setting mode of the “Name” menu. The first segment starts flashing on the display.

With the / buttons you can now select a character. By briefly pressing a button, the display jumps either forwards or backwards to the next character. If you hold down a button, the display starts cycling continuously.

Press the SET button to change to the next segment and select the next character.

Have you entered the name completely? Press the SET button to store your setting and to return to the previous menu level.

Loading the factory-preset default settings

Via the “Reset” menu, you can load the factory-preset default settings. Only the selected setting for the pilot tone remains unchanged. After the reset, the unit is restarted and the standard display is shown on the display panel.

Activating/deactivating the pilot tone transmission or pilot tone evaluation

Via the “Pilot” menu, you can activate or deactivate the pilot tone transmission of the transmitters and the pilot tone evaluation of the receiver.

The pilot tone supports the squelch function (Squelch) and protects against interference due to RF signals from other units. The transmitter adds an inaudible signal, known as the pilot tone, to the transmitted signal. The receiver detects and evaluates the pilot tone, and is thus able to identify the signal of the matching transmitter and mute all others.

Transmitters of the ew 300 series (first generation) do not transmit a pilot tone and the receiver of the ew 300 series (first generation) cannot evaluate the pilot tone. Nevertheless, you can combine units of the ew 300 series (first generation) with units of the ew 300 G2 series (second generation).

However, when combining units, please observe the following:

yWith an ew 300 G2 transmitter and the ew 300 G2 receiver: Activate the pilot tone function with both transmitter and receiver.

yWith an ew 300 transmitter and the ew 300 G2 receiver or vice versa: Deactivate the pilot tone function with the ew 300 G2 transmitter or recei- ver.

33