RCA CC6251, CC6271, CC6151 manual Playback on a TV Without Audio/Video Inputs, Audio, Rf Dc

Playback

Playback on a TV Without Audio/Video Inputs

To connect your camcorder to a TV without audio/video inputs, you need an optional 1CVA147C RF output adapter and an optional coaxial RF cable, such as VH82 or VH90 shown on page 72. If your TV has audio and video inputs (or is connected to a VCR), refer to pages 66-67.

VHF Antenna

Optional Coaxial RF Cable

(such as VH82 or VH90)

OR

Back of TV

VHF

OR
Optional
Transformer
(Such as VH54)	VHF

AUDIO, RF DC

OUT, VIDEO Jacks

OR	OUT TO TV Connector	RF Output
Optional		Adapter's Plug
	VCR/TV Switch
300-75 Ohm

Transformer
IN FROM ANT
Connector	CH3/CH4 Switch	Optional RF Output Adapter
		(1CVA147C)

Installation

1.Disconnect the VHF antenna from your TV. Connect the antenna to the IN FROM ANT connector on the RF output adapter if you are going to leave the adapter connected to the TV.

Note: If your VHF antenna is the flat twin-lead type attached by two screws, you need an optional 300/75 ohm transformer.

2.Attach one end of the optional coaxial RF cable to the OUT TO TV connector on the adapter, and attach the other end to the VHF input on your TV as shown.

Note: If your TV has 300 ohm screw terminals, you need a 75/300 ohm transformer, such as VH54, shown on page 72.

3.Attach the RF output adapter’s plug to the AUDIO, RF DC OUT, and VIDEO jacks located under the small cover on the back of the camcorder.

68