RCA CC6151, CC6271 Playback Operation, Seeing What the Camcorder Is Recording, Normal TV Viewing

Playback

Playback on a TV Without Audio/Video Inputs (continued)

Playback Operation

1.Set the CH3/CH4 switch on the RF output adapter to channel 3 or 4.

2.Turn on the TV, and tune it to the same channel you selected with the RF output adapter’s CH3/CH4 switch.

3.Place adapter’s VCR/TV switch in VCR.

4.Set POWER switch to VCR. Power indicator lights.

5.Press PLAY/PAUSE on the camcorder.

•During playback, use the playback features described on pages 62-63.

6.Press STOP on the camcorder when you are finished.

Seeing What the Camcorder Is Recording

1.Turn on the TV and tune it to channel 3 or 4. Turn the TV’s volume down to prevent a high-pitched squeal caused by feedback.

2.Set the CH3/CH4 switch on the RF output adapter to the same channel you selected on the TV.

3.Set adapter’s VCR/TV switch to VCR.

4.Set POWER switch to CAMERA. Power indicator lights.

5.Press the thumb trigger to begin recording. You can watch what the camcorder is seeing (or recording) on the TV screen.

Normal TV Viewing

For normal TV viewing, leave the RF output adapter hooked up to the TV. Disconnect the adapter’s plug from the

camcorder and place the adapter’s VCR/ TV switch in TV.

Note to Cable TV Installer

This reminder is provided to call your attention to Article 820-40 of the National Electrical Code (Section 54 of Canadian Electrical Code, Part I), that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.

69