RCA CC4251 manual Playback Operation, Viewing What the Camcorder Is Recording, Normal TV Viewing

Playback

Playback Operation

1.Set the CH3/CH4 switch on the RF output adapter to channel CH3 or CH4.

2.Turn on the TV, and tune it to the same channel you selected with the RF output adapter’s CH3/CH4 switch.

3.Press and hold the small button on the CAMERA/OFF/VCR switch while you slide it to VCR.

4.Press PLAY on the camcorder.

•During playback, use the playback features described on pages 34-35.

5.Press STOP/EJECT on the camcorder when you are finished.

Viewing What the Camcorder Is Recording

1.Turn on the TV and tune it to channel 3 or 4. Turn the TV’s volume down to prevent a high-pitched squeal caused by feedback.

2.Set the CH3/CH4 switch on the RF output adapter to the same channel you selected on the TV.

3.Press and hold the small button on the CAMERA/OFF/VCR switch while you slide it to CAMERA.

4.Press the REC/PAUSE button to begin recording. You can watch what the camcorder is seeing (or recording) on the TV screen.

Normal TV Viewing

For normal TV viewing, leave the RF output adapter hooked up to the TV. Disconnect the adapter’s plug from the camcorder or turn the camcorder’s power off.

Note to Cable TV Installer

This reminder is provided to call your attention to Article 820-40 of the National Electrical Code (Section 54 of Canadian Electrical Code, Part I), that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.

39