Yamaha RX-V1500 owner manual Starting the setup, Automenu, SET Menu

Starting the setup

For best results, make sure the room is as quiet as possible during the auto setup procedure (YPAO). If there is too much ambient noise, the results may not be satisfactory.

y

If your subwoofer can adjust the output volume and the crossover frequency, set the volume to about half way (or slightly less) and set the crossover frequency to the maximum.

		CROSSOVER/
VOLUME		HIGH CUT
MIN	MAX	MIN	MAX

Subwoofer

1Switch on this unit and video monitor.

Make sure the OSD is displayed (see page 53).

2Set AMP/SOURCE/TV to AMP, then press SET MENU to enter the SET MENU.

AUTO SETUP

4Press k / n repeatedly to select WIRING,

DISTANCE, SIZE, EQUALIZING or LEVEL.

		1 AUTO:MENU
.			;;;;;CHECK
			;;;CHECK
			;;;;;;;CHECK
			;;FLAT
			;;;;;;CHECK
			;;;;;;;AUTO
			PUSH >
		p/p	: Up/Down
</>			: Select
5 When WIRING, DISTANCE, SIZE or LEVEL is				PREPARATION
	selected, press l / h to select:
	CHECK To automatically check and adjust the selected
		item.
	SKIP To skip the selected item and perform no
		adjustments.
	Note
	When using THX speakers, set SIZE to SKIP and make sure
	that “SMALL” or “SMLx2” is selected in SPEAKER SET
	(page 58) and that 80Hz (THX) is selected in CROSS
	OVER (page 60).

AMP

SET MENU

then MENU

SOURCE

TV

3Press k / n to select AUTO SETUP, then press h once to enter the main menu.

ENTER

SET MENU

. ;AUTO SETUP ;MANUAL SETUP

p/p	:	Up/Down
</>	:	Enter

ENTER

When EQUALIZING is selected, press l / h
to select:
FRONT	To adjust the frequency response of
	each speaker in accordance with the
	sound of your front speakers.
	Recommended if your front speakers
	are of much higher quality than your
	other speakers.
FLAT	To average the frequency response of
	all speakers. Recommended if all of
	your speakers are of similar quality.
LOW	To average the frequency response of
	all speakers, giving priority to the
	accuracy of bass frequencies.
MID	To average the frequency response of
	all speakers, giving priority to the
	accuracy of mid-range frequencies.
HIGH	To average the frequency response of
	all speakers, giving priority to the
	accuracy of high frequencies.
SKIP	To skip the selected item and perform
	no adjustments.

6Press n to select SETUP, then press l / h to select:

AUTO	To automatically perform the entire
	auto setup procedure.
STEP	To pause for confirmation between
	each check in the auto setup procedure.
		English
RELOAD	To restore the last auto setup setting.

27