Rear Panel Switches and Terminals
Table 2±2. External Synchronization Terminal Resistance Switch SW4
Switch Position | Terminal Resistance Value |
Left | 75 Ω |
Center | 100 kΩ |
Right | 150 Ω |
Figure 2±2. External Synchronization Terminal Resistance Switch SW4
Left Right
Center
Note:
When outputting internal sync signal, set the switch to 100 kΩ.
2.2.3Mode Switches SW3
The SW3 mode switches control the functions listed in Table 2±2 and Table 2±4.
Table 2±3. Mode Switches SW3
Switch No. | Mode | Operation |
1 | Shutter 1 | Refer to list below |
2 | Shutter 2 | Refer to list below |
3 | External sync | ON for external sync |
4 | External sync | ON for external sync |
5 | Interlace/noninterlace | ON for interlace |
6 | Not used |
|
Table 2±4. Shutter list
Shutter 1 | Shutter 2 | Mode |
OFF | OFF | Shutter OFF (1/60 sec. exposure) |
ON | OFF | Continuous shutter, see Note 1 |
ON | ON | Continuous shutter, see Note 2 |
OFF | ON | V.I. (Variable Integration) |
Notes: 1) V reset not done when external trigger is input.
2)V reset done when external trigger is input.
2.2.4Gain Mode Switch SW2
Gain mode switch SW2 controls the gain as shown in Table 2±5 and Figure 2±3.
Nomenclature and Use of Each Component |