Chapter 2: Installation
LAN1/2 Enable/Disable
Change the setting of jumper JPL1 and JPL2 to enable or disable the LAN1 and LAN2 Ethernets ports, respectively. See the table on the right for jumper settings. The default setting is enabled.
Compact Flash Master/Slave Select
A Compact Flash Master (Primary)/Slave (Secondary) Select Jumper is located at JCF1. Close this jumper to enable Compact Flash Card. For the Compact Flash Card or the Compact Flash Jumper (JCF1) to work properly, you will need to connect the Compact Flash Card power cable to JWF1 first. Refer to the board layout below for the location.
LAN1/2 En/Disable
Jumper Settings
(JPL1/JPL2)
Jumper Setting | Definition |
|
|
Pins | Enabled |
|
|
Pins | Disabled |
|
|
Compact Flash Card Master/
Slave Select (JCF1)
Jumper Setting | Definition |
|
|
Open | Slave (Secondary) |
|
|
Closed | Master (Primary) |
|
|
SAS Enable/Disable
JPS1 allows you to enable or disable the SAS controller. The default position is on pins 1 and 2 to enable SAS. See the table on the right for jumper settings.
SAS RAID Mode Select
JPS2 allows you to select the SAS RAID mode, either Software RAID or IT Mode. Close this jumper to use Software RAID (the default setting). Set this jumper to open to use the IT Mode.
SAS Enable/Disable
Jumper Settings (JPS1)
Jumper Setting | Definition |
|
|
Pins | Enabled |
|
|
Pins | Disabled |
|
|
Software RAID
Jumper Settings (JPS2)
Jumper Setting Definition
Close | Software RAID |
| Enabled |
|
|
Open | IT Mode Enabled |
|
|