Sharp SND-5080 Verify the settings in the following sequence, Check Data & Time settings, Card

appendix

PROBLEM		SOLUTION
No JPEG file is transferred via	y Verify the settings in the following sequence:
e-mail on occurrence of intelligent		A. Check <Data & Time> settings.
video analysis event of camera		B. The <IV analysis Function> should be set to <Enable>.
even when the <IV analysis
Function> is set to <Enable>.		C. Alarm Video Transmission must be enabled.
Can <Set Rules> be configured	y Yes, it can be. You can set rules for events despite of the intelligent
even when the <IV analysis		video analysis setting.
Function> is set to <Disable>?
No signal is found at the Alarm
Output port even when an	y	Check alarm output port settings.
intelligent video analysis event is
generated.
Cannot record into the SD memory	y Check if the memory card is defective.
card.	y Check if the write protection tab of the memory card is set to "Lock".
SD memory indicator does not	y Check if the memory card is defective.
turn on even when the SD memory	y Check if the <Record> is checked in <Setup> € <Event> € <SD
card is inserted.		Record> menu.
SD memory card is inserted but	y Check if the memory card is inserted in the proper direction. Operation
		of memory card that is formatted by other devices is not guaranteed with
the camera does not operate		this camera unit
properly.	y Format the memory card again in <Setup> € <Event> € <SD
		Record> menu.
Cannot format the SD memory	y Check if the write protection tab of the memory card is set to "Lock".
card.

92_ appendix