Step 4—Insert the Holder
Check the status LED |
|
1 Make sure that the status LED is glowing |
|
steadily. Do not insert film holders while |
|
the status LED is blinking. |
|
Find the arrow on the front of the holder |
|
2 The front each holder is marked with | Arrow |
an embossed arrow showing the direc- |
|
tion of insertion. When the holder is |
|
inserted, the side with the arrow should |
|
face up with the arrow pointing toward |
|
the scanner. |
|
Insert the holder |
|
3 Keeping the holder straight, slide the it |
|
into the holder slot with the arrow up |
|
and facing toward the scanner. Once |
|
the holder has been inserted as far as the |
|
insertion guides, the automatic loading |
|
mechanism will activate. Remove your |
|
hands from the holder when loading |
|
starts. When loading stops, the holder |
|
is in scanning position. |
|
Inserting Holders
If the loading mechanism is does not ac-
tivate, remove the holder and try again.
Do not use force. Once loading hasInsertion guide begun, do not interfere with the load-
ing mechanism. Attempting to remove the holder during loading or otherwise interfering with the mechanism could cause scanning errors.
Calibration
The scanner is automatically calibrated at regular intervals if left on with no holder in place. Calibration will end when a holder is inserted.
32