Sharp MD-E9000H operation manual Special Notes

Page 2

Special Notes

Important Instruction

- Special Notes -

NOTES FOR USERS IN THE U.K. AND IRELAND

The mains lead of this product is fitted with a non-rewireable (moulded) plug incorpo- rating a 3A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or and of the same rating as above, which is also indicated on the pin face of the plug must be used.

Always refit the fuse cover after replacing the fuse. Never use the plug without the fuse cover fitted.

In the unlikely event of the socket outlet in your home not being compatible with the plug supplied, cut-off the mains plug and fit an appropriate type.

DANGER:

The fuse from the cut-off plug should be removed and the cut-off plug destroyed immediately and disposed of in a safe manner.

Under no circumstances should the cut-off plug be inserted elsewhere into a 13A socket outlet as a serious electric shock may occur.

To fit an appropriate plug to the mains lead, follow the instructions below:

IMPORTANT:

The wires in the mains lead are coloured in accordance with the following code: Blue : Neutral

Brown : Live

As the colours of the wires in the mains lead of this product may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

The wire which is coloured blue must be connected to the plug terminal which is marked N or coloured black.

The wire which is coloured brown must be connected to the plug terminal which is marked L or coloured red.

Ensure that neither the brown nor the blue wire is connected to the earth terminal in your three pin plug.

Before replacing the plug cover, make sure that:

If the new fitted plug contains a fuse, its value is the same as that removed from the cut-off plug.

The cord grip is clamped over the sheath of the mains lead and not simply over the lead wires.

IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN.

SERVICE INFORMATION

In the unlikely event of your equipment requiring repair, please contact the dealer or supplier from whom it was purchased. Where this is not possible, please visit our web-site www.sharp.co.uk/support.

Customers without internet access may telephone 08705 274277 during office hours (or (01) 676 0648 if telephoning from Ireland).

Please note; all calls will be charged at local rate.

Certain replacement parts and accessories may be obtained from our main parts distributor.

WILLOW VALE ELECTRONICS LTD.

0121 766 5414

In the unlikely event of this equipment requiring repair during the guarantee period, you will need to provide proof of the date of purchase to the repairing company. Please keep your invoice or receipt, which is supplied at the time of purchase.

WARNINGS

When the ON/STAND-BY button is set at STAND-BY position, mains voltage is still present inside the unit. When the ON/STAND-BY button is set at STAND-BY position, the unit may be brought into operation by the timer mode or remote control.

This unit contains no user serviceable parts. Never remove covers unless quali- fied to do so. This unit contains dangerous voltages, always remove mains plug from the socket before any service operation and when not in use for a long period.

To prevent fire or shock hazard, do not expose this appliance to dripping or splash- ing. No objects filled with liquids, such as vases, shall be placed on the apparat- us.

CAUTION

Use of controls, adjustments or performance of procedures other than those speci- fied herein may result in hazardous radiation exposure.

As the laser beam used in this compact disc player is harmful to the eyes, do not attempt to disassemble the cabinet. Refer servicing to qualified personnel only.

NOTES

Recording and playback of any material may require consent, which SHARP is unable to give. Please refer particularly to the provisions of the Copyright Act 1956, the Dramatic and Musical Performers Protection Act 1958, the Performers Protection Acts 1963 and 1972 and to any subsequent statutory enactments and orders.

This equipment complies with the requirements of Directives 89/336/EEC and 73/ 23/EEC as amended by 93/68/EEC.

US and foreign patents licensed from Dolby Laboratories.

2

Web-site:www.sharp.co.uk/support Help Line: 08705 274277 (office hours)

*MD9000H-E02-03

2

2001.4.20, 2:01 AM

Image 2 Sharp MD-E9000H operation manual Special Notes
Contents MD-E9000H Special Notes Special NotesContents General PrecautionsVolume control Care of compact discs AccessoriesGeneral Information Precautions / Accessories 7 8 9 10 11 12 13 16 17 Controls and IndicatorsGeneral Information Controls and Indicators Front panelDisplay Rear PanelControls and Indicators Remote ControlTweeter Woofer Bass Reflex Duct Speaker Terminals Speaker SystemSpeaker connection Placing the speaker systemAerial connection Connecting the AC power leadSystem Connections For Use ConnectionsTest of the remote control Remote ControlBattery installation Preparation for Use Remote ControlGeneral Control Demonstration modeTo turn the power on To change the display brightness 2 levelsBass control Adjusting the volumeSound Control EqualiserTo check the time when the power is on SettingBasic Operation Setting the Clock Press the CD 06 button to start playback from track Listening to a CDCD Playback Listening to a CD To interrupt playbackTo locate the desired portion Listening to a CDTo locate the beginning of a track Press the MD 06 button to start playback Listening to a MiniDiscMD Playback Listening to a MiniDisc Listening to a MiniDisc To remove a MiniDiscProgrammed Play Programmed PlayDirect Play Direct Play Repeat or Random PlayRepeat or Random Play Switching the display during MD playback Switching the DisplaySwitching the time display Advanced CD/MD Playback Switching the DisplayRadio Listening to the Radio Auto tuningListening to the Radio To receive an FM stereo transmissionTo recall a memorised station Listening to a Memorised StationMemorising a station To clear all memorised stationsInformation provided by RDS Using the Radio Data System RDSUsing Data System RDSRDS To erase all of the contents of preset memory Using the Radio Data System RDSUsing the Auto Station Programme Memory To stop the Aspm operation before it is completeIf you select the traffic programme To recall stations in memoryTo specify programmed types and select stations PTY search To cancel the EON stand-by mode EON-PTYTo automatically play the traffic information EON-TIAbout the TP and TA indicators MeaningAbout track numbers Before Recording to a MiniDiscDifferences from tape recordings Disc writing TOCMD Recording Recording to a MiniDisc from a CD Recording to a MiniDisc from a CDRecording to a MiniDisc from a CD One Touch Editing Load a CD and a recordable MiniDisc Press the REC button To record without using One-Touch EditingMD Recording Programmed recording from a CD Recording to a MiniDisc from a CDRecording the first several tracks of a CD Press the MD 06 button Recording to a MiniDisc from the RadioMD Recording Recording to a MiniDisc from the Radio To interrupt recordingMD Editing Titling a MiniDisc Titling a MiniDiscCreating disc and track names Press the MD button and load a MiniDisc seeMiniDiscaTitling To combine tracks Editing a Recorded MiniDiscTo divide a track MD Editing Editing a Recorded MiniDiscTo move a track To move programmed tracks programmed moveTo erase all of the tracks at once Editing a Recorded MiniDiscTo erase a track To erase programmed tracks programmed EraseAdvanced Features Timer and Sleep Operation Timer and Sleep OperationTimer playback/Timer recording To cancel the timer operation Timer and Sleep OperationTo confirm the timer setting Sleep operationSimultaneous sleep and timer operation To confirm the remaining sleep timeListening to the playback sounds from Connected device HeadphonesEnhancing Your Stereo System Recording on a MiniDiscWhat is a What is a MiniDisc?Helpful tip when attaching a label MiniDisc System LimitationsWhen an error message is displayed, proceed as follows Error MessagesError Messages CD player Troubleshooting ChartTroubleshooting Chart MiniDisc TunerMaintenance Troubleshooting ChartAmplifier SpecificationsSpecifications MiniDiscMemo Memo Sharp Corporation