TANDBERG 1000, 550 user manual Handling Calls, Placing a Call, Answering a Call, Ending a Call

Page 16

Getting started	TANDBERG 1000/550 for Cisco CallManager

Handling Calls

Placing a Call

There are three ways to place a call:

A. Use the NewCall softbutton. A dialing tone is heard and the desired number can be entered. To delete a digit, use the << soft-button. To cancel the number entry, use the EndCall softbutton or press DISCONNECT. When the required number of digits has been entered the call will proceed automatically.

B. Just start entering the number using the number keys. No dialing tone will be heard in this case. To delete a digit use the <<. When the required number of digits has been entered press the Dial softbutton and the call will proceed.

C. Press CONNECT. A dialing tone is heard and the desired number can be entered. To delete a digit, use the << soft-button. To cancel the number entry, use the EndCall softbutton or press DISCONNECT. When the required number of digits has been entered the call will proceed automatically.

NOTE

USING THE CONNECT BUTTON ONLY WORKS FOR THE FIRST CALL MADE. IT WILL NOT WORK IF YOU ARE TRYING TO INITIATE A SECOND CALL WHILE HAVING ANOTHER CALL ON HOLD.

Answering a Call

connect

To answer a call, use the Answer softbutton or press CONNECT.

TIP

ON T1000 FOR CISCO

CALLMANAGER THE PUSHBUTTON AT

THE FRONT OF THE SYSTEM CAN BE

USED TO ANSWER

Ending a Call

disconnect	To end a call, use the EndCall softbutton or press DISCONNECT.

16

Image 16

Contents Tandberg For Cisco CallManagerTrademarks and copyright Operator Safety Summary Equipment MarkingsContents On Screen Symbols Directory SettingsMain Menu Placing a Call Answering a Call Ending a CallT1000 for Cisco CallManager Peripheral Equipment Appendix 1 IP Password Appendix 2 Declaration of ConformityT550 for Cisco CallManager Peripheral Equipment Introduction Menu structure Main MenuPrecautions InstallationConnecting Your Tandberg 1000 for Cisco CallManager System Wireless LAN Insert PC Card Power CableLAN Cable Connecting Your Tandberg 550 for Cisco CallManager System Microphone Cable Monitor CablesScart Europe Scart Europe & RCA/S-Video USPower Cable Standby Mode Getting StartedBefore You Begin Welcome ScreenRemote Control Quick keysCamera control and menu navigation keys Dialing keysHandling Calls Placing a CallAnswering a Call Ending a CallAdjusting Volume General UseView Outgoing Video Selfview Microphone on/offControlling the Camera On Screen SymbolsMoving / zooming Camera Advanced Use Main MenuCalls Placing a Call on HoldResuming a Call on Hold Transferring a Call to Another ExtensionDirectory ServicesRedialing the Last Number Dialled Settings View StatusTIP Tftp DNS Network Settings Page Recommended access point Required cardsPage Audio Settings Video SettingsData Port Settings MessagesPeripheral Equipment T1000 for Cisco CallManager Peripheral EquipmentPC-interface serial cable Headset InterfaceT550 for Cisco CallManager Peripheral Equipment Kensington LockAppendix 1 IP Password AppendicesAppendix 2 Declaration of Conformity Tandberg 1000/550 for Cisco CallManager Appendices Index

Related manuals

Manual 2 pages 27.8 Kb