TOA Electronics C-CV44-3 NTSC Adjustment, Removing the sunshade Removing the front cover

Page 10

6. ADJUSTMENT

1. Detach the sunshade and front cover after completing camera mounting and connections.

[Removing the sunshade]

[Removing the front cover]

Loosen the two sunshade fixing screws.

Pull out the sunshade after rotating.

Turn the front cover in the direction indicated by the arrow to remove.

Front cover

2. Connect the Monitor output terminal to the monitor.

Note: The camera will not operate, even if this terminal is connected to the camera drive.

3.Switch on the power to the camera, permitting a picture to be viewed on the monitor.

4.Set the Mode setting switch for the best possible picture reproduction, depending on the installation conditions.

•Set the Shutter speed switch to the ON position when light flicker is an annoyance.

•Set the Backlight compensation switch to the ON position when a subject appears blacked-out. For more information on these switches, refer to p. 13; “About the Mode Switch.”

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Outdoor Color Camera C-CV44-3 Ntsc C-CV44-3 PAL Table of Contents Safety Precautions Safety Symbol and Message ConventionsGeneral Description Handling PrecautionsModifications Nomenclature External ViewInstallation and Connections Ceiling mounting example Wall mounting exampleMounting Example 3 Ceilings or walls Connector Mount the water-resistant cap to the camera Adjustment Removing the sunshade Removing the front coverCamera mounting bolt Ceiling mounting example Backlight Compensation Switch About the Mode Setting SwitchAdjustment Switch Shutter Speed SwitchIf YOU Think There is a Failure Troubleshooting Specifications Accessories
Top Page Image Contents