TOA Electronics C-CV44-3 NTSC instruction manual Mount the water-resistant cap to the camera

Page 9

5. Mount the water-resistant cap to the camera.

Note: If there is a gap between the water-resistant cap and the mounting surface, water can get in and expose the connector to corrosion. To avoid equipment failures, check to be sure that the water- resistant cap is attached correctly.

Fit the watertight cap (shaded section) securely to the camera.

6.Connect the camera to the monitor and power supply source. Refer to the following figure to make connections.

Monitor

Video input

: BNC plug

Video output

24 V AC or 12 V DC

Use the external power supply unit of the following rating when the camera is operated on 12 V DC.

12 V DC, over 1.0 A

Camera Input/Output terminal

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Outdoor Color Camera C-CV44-3 Ntsc C-CV44-3 PAL Table of Contents Safety Symbol and Message Conventions Safety PrecautionsHandling Precautions General DescriptionModifications External View NomenclatureCeiling mounting example Wall mounting example Installation and ConnectionsMounting Example 3 Ceilings or walls Connector Mount the water-resistant cap to the camera Removing the sunshade Removing the front cover AdjustmentCamera mounting bolt Ceiling mounting example Adjustment Switch About the Mode Setting SwitchBacklight Compensation Switch Shutter Speed SwitchIf YOU Think There is a Failure Troubleshooting Accessories Specifications
Top Page Image Contents