TOA Electronics C-CV44-3 NTSC instruction manual Installation and Connections

Page 6

5. INSTALLATION AND CONNECTIONS

[Ceiling mounting example]

[Wall mounting example]

Bracket mounting bolt (M8 or W 3/8)

Security wire entry hole

Camera mounting bolt Washer-installed M8 x 14mm hex bolt (standard accessory)

Install the unit only in a location that can structurally support the weight WARNING of the unit and the mounting bracket. Doing otherwise may result in the

unit falling down and causing personal injury.

Note: Attach the security wire as required. Carefully check to confirm the cable length, cable diameter, and hook strength, since the shock produced by a camera dropping is very high.

1.Confirm the mounting bracket’s installation location, and determine its mounting direction and position. Three mounting methods are possible, depending on the installation location.

120º

Used in mounting example 3.

12 mm

Used in mounting examples 1 and 2.

4 -ø6.5 mm

ø50 mm 70 mm

76 mm

 

96 mm

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ø10.5 mm

97.6 mm

6

Image 6
Contents Outdoor Color Camera C-CV44-3 Ntsc C-CV44-3 PAL Table of Contents Safety Precautions Safety Symbol and Message ConventionsHandling Precautions General DescriptionModifications Nomenclature External ViewInstallation and Connections Ceiling mounting example Wall mounting exampleMounting Example 3 Ceilings or walls Connector Mount the water-resistant cap to the camera Adjustment Removing the sunshade Removing the front coverCamera mounting bolt Ceiling mounting example Backlight Compensation Switch About the Mode Setting SwitchAdjustment Switch Shutter Speed SwitchIf YOU Think There is a Failure Troubleshooting Specifications Accessories