TOA Electronics C-CV44-3 NTSC instruction manual Connector

Page 8

3.Attach the camera to the mounting bracket.

Use the supplied insulation spacers, camera mounting bolts (washer-installed M8 x 14mm hex bolt) to attach.

Note: Because the induced voltage and noise may be generated at the camera mounts, depending on the installation environment, be sure to use insulation spacers and washers when attaching. Also, never remove the insulation washers attached to the mounting bracket.

Mounting bracket

Camera mounting bolt

Washer-installed M8 x 14mm hex bolt

Insulation spacer

Insulation washers are attached to the mounting bracket.

4.Connect the connector.

Connect the connector of the supplied cable with the water-resistant cap to the camera’s Input/Output terminal, then tighten the connector’s lock screw.

Notes

•Be sure to fully insert the connector to prevent rainwater from getting in the Camera.

•Wrap the self-adhesive type butyl rubber tape round cable joints to prevent rainwater from entering.

Connector

UL1095#22 Black/ White (Nonpolar)

(water-resistant type)

 

Water-resistant cap

Cable joint section

Connects to power supply source

Connects to monitor

Lock screw

BNC jack

BNC plug

 

Camera Input/

Supplied cable

 

Output terminal

 

 

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Outdoor Color Camera C-CV44-3 Ntsc C-CV44-3 PAL Table of Contents Safety Precautions Safety Symbol and Message ConventionsModifications Handling PrecautionsGeneral Description Nomenclature External ViewInstallation and Connections Ceiling mounting example Wall mounting exampleMounting Example 3 Ceilings or walls Connector Mount the water-resistant cap to the camera Adjustment Removing the sunshade Removing the front coverCamera mounting bolt Ceiling mounting example About the Mode Setting Switch Adjustment SwitchBacklight Compensation Switch Shutter Speed SwitchIf YOU Think There is a Failure Troubleshooting Specifications Accessories
Top Page Image Contents