7. ABOUT THE MODE SETTING SWITCH
Set the Mode Setting switch for the best possible picture reproduction depending on installation conditions.
OFF ON
F. ADJ
BLC
1/60 1/100
SHUTTER
IRIS
LH
Mode Setting Switch
OFF ON
Adjustment switch
Backlight Compensation switch
Shutter Speed switch
(NTSC) 1/60 | 1/100 |
(PAL) 1/50 | 1/120 |
7.1. Adjustment Switch
Set this switch when adjusting the lens focus. (Provides the same effect as when using the ND filter.)
OFF ON | Standard position : |
| |
| Set to OFF after lens adjustment completion. Set to this position during normal use. |
OFF ON Adjustment position (during adjustment) :
Use this position when focusing the lens. If the focus is adjusted for a subject under good lighting conditions, the subject may go out of focus when conditions become
dark. Set the Adjustment switch to ON only when performing focus adjustment.
Note: The color of the screen may periodically vary under fluorescent lighting when the Adjustment switch is set to ON.
7.2. Backlight Compensation Switch
Set this switch so that the subject is not displayed in black when backlit.
OFF ON
Standard position :
Set to this position during normal use. Backlight Compensation function does not operate when the switch is set to this position.
OFF ON | Backlight Compensation position (when backlit) : | ||||||
|
|
|
|
|
|
| This position prevents images from being displayed in black when the image is |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| backlit. |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
7.3. Shutter Speed Switch
Set this switch to the ON position when annoying screen image flicker is detected.
OFF ON
OFF ON
Standard position :
Set to this position during normal use.
Shutter Speed position :
Annoying screen flicker may result under fluorescent lighting in areas operating with a power frequency of 50 Hz (NTSC) or 60 Hz (PAL). In such cases, set the Shutter Speed switch to the ON position to permit a
Note: If the Shutter Speed switch is set to the ON position, sensitivity is reduced compared to operation in the OFF position. When using the camera in a dark location, or where light flicker is not an annoyance, set the switch to the OFF position.
13