ParkerVision 1-CCD manual Installation and Startup, Mounting Your CameraMan Camera

Section

2 Installation and Startup

Mounting Your CameraMan Camera

You can mount your CameraMan camera on any flat, non-slick, nonmetal surface with a minimum supporting area of 8" x 8". Follow the instructions below:

1.Check your selected camera location to ensure that you have

	enough camera and cable clearance space for the CameraMan			18.0”
!	camera to pan and tilt without obstruction.		x
	Do not mount the camera upside down or with more
	than a 10 degree angle from horizontal.
	Refer to Appendix E, Field of View Specifications, to	12.0”				22.0”
	assist you with positioning the CameraMan camera to
	achieve optimum optical views.
					3.0”
2. Locate the zero-degree position mark labeled "Front" on the			x
	bottom of the base unit. This mark helps ensure that the base
	unit is calibrated correctly.

Point this indicator mark in the direction that best reflects the center of travel for the camera. (This is usually the center of the room.)

!Lift the unit by its base, not by its tilt assembly.

3.To ensure that the mounting surface is not prone to vibrations, fasten the camera to a flat, rigid surface using a 1/4"-20 UNC cap screw that does not extend into the base platform by more than 0.4". (The cap screw is not included.) To use a 3/8"- 16 UNC cap screw, remove the insert provided in the mounting screw hole.

!To avoid overtightening, tighten this screw by hand. If necessary, use a non-hardening threadlock to prevent the screw from loosening. Overtightening can prevent the camera from panning properly and may damage the unit.

Never attempt pan or tilt movement by hand. Always use a control device.

!Always operate the camera indoors and follow the temperature and humidity specifications outlined in Appendix B, Camera Specifications.

Zero degree pan position mark

3/8"-16 UNC Mounting Screw Hole with 1/4"-20 UNC insert.

CameraMan 1-CCD Camera System Installation and Operations Manual 2-11