ParkerVision 1-CCD manual Connecting the Power Supply

Installation and Startup

Connecting the Power Supply

You can mount the power supply with any orientation or on top of a table or roll-about unit. Follow the steps below:

1.Verify that the power switch located on the back of the camera is turned off.

2.Plug the 5.5mm female connector of the power supply into the DC POWER jack on the back of the camera.

3.Connect the other end of the power supply into a 120 VAC source.

!Do not modify the length of the AC or the DC wiring.

PVI COM	RS-232	S-VIDEO	COM POSITE	DC
		OUT	VIDEO OUT	POWER
RS-485	AUX A
				POWER

2-14CameraMan 1-CCD Camera System Installation and Operations Manual